Jump to content

Harrm

Members
  • Posts

    8
  • Joined

  • Last visited

About Harrm

  • Birthday August 26

Location

  • Location
    Wales

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Harrm's Achievements

Z Hopeful

Z Hopeful (2/7)

4

Reputation

  1. Martin harry 1 ticket paid no track time
  2. Harrm

    Ac issue

    Changed my ac condenser, low pressure pipe (smaller of 2) blows off on pressure test. I did put new o ring on but it's very loose so think the pipe is well worn. Does this mean whole line needs changing? and how big a job is it? Can it be cut and recoupled and does any1 recommend any1 to carry out the work. South wales area
  3. Anybody able to help I need 6 of these ASAP I'm in South wales. Zman can get them to me next week but could do with em soo er if poss. Or does anybody know the thread pitch and length?
  4. Booked and paid. 1st time on a z stand look forward to it. My son and I driving up from South wales probably stop at a premier inn night before
  5. None of the sensors were oem so I can only think that they needed changing anyway and were not related. I wonder if there could be a dodgy coil. Is there a way of testing them? I've taken them out individually and they look good to the eye (no cracks etc)
  6. Apologies if I'm posting this in the wrong place this is 1st time I've posted. So I'm now getting really fed up of searching for my issue. Here goes it's a bit long winded. Had the car a year and half and the car has done it from day 1. Start it and drive it cold and half way to normal temp (normally after about 2 mins of driving) she starts blubbing exhaust turns to a deeper tone and at low revs is almost jerky. If left to idle to temp this doesn't happen at all, unless you stop the car and switch it back on then it happens again for a few minutes then clears itself. There are no EML on. So I got a jobd reader last week and it read 5 faults P0021, P0024, P0024, P0011, and P1078. All to do with exhaust valve timing and intake valve timing bank 1 and 2. So I changed all 4 sensors, 2 x cam shaft positioning and 2 x exhaust valve control positioning. After mixing these around a bit hey presto, no fault codes. Out for a spin but the issue still remains. It may seem petty but apart from this issue the car is faultless and I really want to solve it. Before this I have swapped MAF, crank sensor, checked vacuum pipes, cleaned throttle body, tried a 2nd throttle body, cleaned exhaust valve solenoids, Checked plugs and fully serviced. So I'm pleading for help/suggestions I'm next going to try changing the thermostat, I've also been told mixed stories about the flywheel being a possibility as it has had an aftermarket clutch and lightened wheel 3 years ago? Thanks for reading people appreciate any advice and ideas. Martin
  7. South wales near the airport mate
  8. Hi just signed up picked up my 1st 350z on friday from Wales. Many of you about in Wales? I have an 06 rev up
×
×
  • Create New...