craigbev92

R&D spark plug kit ordered and received the next day, cracking service... now to attempt the job!

can I take it?

any kits left?

Might be a little bit late in joining in the 'yard sale' a few things I need for the zed are a roof lining, boot dampers, and a few clips to fix my boot lining properly if you have any laying around. cheers

I'm not far from either driftworks or mishimoto in all fairness so hoping it can be easy to arrange something

Yeah bought from driftworks just really need to be able to exchange it on the day tomorrow!

Title says it all, ordered mishi fans and rad to replace my recently broken ones, delivered today and the radiator was bent! it also didn't fit at the top but did at the bottom. it was out by about 1cm to 2cm on the A/C rad and top holes. didn't know if anyone had any experience of this or whether the bend is the cause. Here is a picture....

yeah I had to do the motors when I bought the darn thing!

Tried to PM you but you cannot receive any new one! do you have any 'B' fans?

okay so the fan shroud itself is okay however the propeller itself needs replacing. radiator is a small hole so new rad is the way to go!

Hi guys and gals, in need of assistance! Bumped the bottom of the Zed earlier today and although there is no visible damage to the underside etc. my fan has decided to spin its way through my radiator! its squirting out coolant but not at a waterfall pace near the bottom of the rad and the fan is no longer attached to the motor properly. going to take this off and investigate now but was wondering what im looking at parts wise/ cost wise. terrible day! cheers

Is it easier to fit in an aftermarket amp if I can find one with similar power rating?

Ok so wired in fine and up and running! Next problem is that the sub keeps cutting out and turning on when it feels like it! What can I put this down to? Craig

Okay so between the pac unit and the HU or between the pac and the cars iso? I've only ever done plug and play I'm afraid :wacko:

I haven't no. How would I go about this? Splicing into the the ground wire on the HU harness?