danj00

Cheers, I'll get in touch with them.

Turns out the sensor wasn't working propely due to some rust on the sensor. I sandpapered the rust off and now it's working perfectly. Hope this helps anyone else who has this issue in the future.

Hello, Does anyone have any reccomendations for a body shop in the Yorkshire area/up north? I've got some bad rust developing on the rear wheel arch which I'd like to sort sooner rather than later. Thanks in advance

Hello, Ever since I’ve owned my 350z the handbrake light has never worked. I took apart my centre console to check the wire and it’s at 8v and the light in the dash works. Are there any common faults? Does anyone have any ideas? thanks in advance

Well I discovered my issue, should’ve checked the wiring…

Which wire should I ground out? There’s 3 separate ones, 12V, ground and the signal. Thanks

Hi, So I’m new to Z ownership and I have done an oil change and filter change. Afterwards, my oil pressure was reading as 0 and the oil light was on. I assumed it was the oil pressure sensor because it’s near the filter and I had a hard time getting the filter off so I could’ve damaged it in some way there. I have tried 2 sensors now, a cheap eBay one and and OEM one from Torqen but the issue is exactly the same. I did a pressure test with a mechanical testing gauge and the pressure was good, so I know it’s not anything terrible. I’m just a bit stuck as to where to go from here. Anyone got any ideas? Thanks