toner

Hi have you still these in stock?

Haha I shouldn't have access to a hammer are a spanner cause it will break are the bolt will ring 🙈

Went I was working on it I hit it with a hammer as snap

Were it connected to the hub the fork but snapped

This is what I'm after I broke mine today 😔

Thanks this helped a lot bud. I could just put the standard traction arm back in and just use the camber arm and the tie arm when I get it? Sorry for being a pain 🙈

I got my lips from Rotiform once you put lips on your wheel the et changes plus I have 20mm spacers and I had to face mount the wheels to get them to fit the rear if I was to guess the front would be et 0 and the rear et is - 15

Hi I'm trying to get an arm to replace the spring holder arm so when I put camber on I can correct the toe the standard bolt just isn't enough

Thanks

A is what I'm calling the caster arm. B is what I'm calling the camber are then c the spring pocket arm I have seen arms that delete the spring pocket but only in a America. I'm wondering is there anyone over here do them are has anyone used different arms like e36 bmw camber arms are just to long. I'm only looking about -2 degrees at driving height then when the car is fully down the natural camber of it going so low will make the extra degree here's a picture.

Hi guys I've had so much trouble with my rear alignment. I'm trying to get camber about -4 degrees. I have the caster arm and the camber arm but when I put that amount of camber on I run out of toe till straightin the wheel out. The arm I think is the problem is the spring cup arm I have hydraulic so I have on spring there any more. I'm wondering has anyone had this problem what have they done are can anyone shed some light one what can be done.

Thanks

Ah god iPhones 😔 posted 3 times

I

Hi I have change all me dishes do I'm not to sure on my wheels et's but there 18x10.5 and 18x13 I measured them at

I few interior shots

Got a splitter and side steps off tarmac I haven't got the splitter painted put the side side are close till the ground 😉👌

Haven't updated my thread in a while just thought I put a few pictures up

Hi after the bolt covers I need 6 but 4 would do here a picture to explain what I'm looking

I

So I got the side diffuser on just about. Lol not much room

I don't know what it's dropped the subframe is on the ground. I'll just run the car abit higher when I'm driving it. I'm just wondering when I put it fully down will the side diffusers hold it up

My looking to know how much lower the side step sits just wondering could I get it to fit were the arrow is pointing

Thanks 😃

Just a quick question would a de 350z gearbox fit a hr 350z ?

I'm looking a facelifted splitter I side skirt add ons and a diffuser cash waiting

Here a picture of the car near done

So my new dishes came 😃😃