DR_EVIL999

Andorra is way better than France.. Drinks are cheap!

Where did you get your oil pump? I've seen a couple of suitable ones on ebay.

Yes it should be a img link.

Your photobucket is doing the same as mine...

Sent from my iPad using Tapatalk

I'm looking at building a low boost mid mount setup on mine, have a holset hx35 laying around. Just gathering bits so far. Guess i'll post a thread up when I start.

Any progress on this?

You need a bit of pipe the same diameter as the rest if the mid section, once the box is cut out this will be welded in its place.

I removed the silencer in the mid pipe a few weeks after getting my Z, It made it louder and more raspy. Sounded good.

ive got some 15mm hub centric ones i had on the rear of mine, u can use a 5 or 10mm spacer to bring it out further if you are interested at all.

I'm interested How much?

How much?

I've got the rears fitted but still looking for the fronts to finish the look.

I paid £7885 for my GT spec three years ago. 79000 motorway miles and a full Nissan service history.

I have checked all I have is the pressure plate

Thanks I've got one now.

I have a used dual mass flywheel sitting in my garage.

 

Yours for the courier fee or pick up for free from Cambridgeshire.

Hopefully I don't need a flywheel. Only problem is a stiff clutch pedal that's slowly getting worse (95000 miles)

Today I was told I look like "Paul Simon in the 70's" haha, not sure how good or bad that is. I've raised £62.50 so far.

I'll be taking it to be modified and fitted with new friction material then swapping it for the worn out plate in my car.

Let me know if you have one please.

Does this car still have a set front discs? (brembo) I'm looking to replace my warped ones and also one of the boot lifters, the small ones that pop the boot up when the button is pressed.