SlyBacon

Only code is p2101 

10 hours ago, Chrissaxon said:

It sounds like a faulty crank sensor . There are four . 2 on each side . Bank 1 and Bank 2.  They can break down . Easy to replace . 

Would they give the same code as the throttle body? 

6 minutes ago, ZMANALEX said:

If the throttle body is fully functional and you are getting fuel and spark, then I would start by looking at the battery condition.

 

 

It's turns over as it should battery is less than a year old

Hi all, 

Car has been sat over the winter approximately 6 weeks, she ran like a dream until it was parked up. 

Go to start it today and nothing, it turns over and does inject fuel but will not start! 

Plugged a code reader in and got p2101 which is to do with the throttle body. So I took the intake off and got rid of the small amount of crud in front of the valve. Reset the codes and tried starting again. 

Still no start... Any advice where to check next? 

Thanks 

James

Hi all,

Looking to buy 20mm front and 25mm rear spacers for my zed, I have the standard 18" rays and the car is rather low on bc coilvers. I think I will have to raise the height a little otherwise major rub will happen  

Has anyone got a similar set up?

Hi all, 

Just wondering if anyone has used these on their zeds? 

2006 with brembos

8 minutes ago, MattRwebB said:

Glad you just put this up I’ve just changed my plugs and my back right hand (standing in front of the car) was covered in oil .. rest are dry .. will keep and eye on on this post

Same on my 06, no misfire though... Was led to believe its the rocker cover gasket

Looking around to see if anyone has one for sale in South, ideally cat back. Thanks

6 hours ago, StevoD said:

then you need to move down from an 11j or carry out arch work unfortunately 

I don't mind a little arch work... I would move down from an 11j, but I've really got my eyes set on the jr18's.

Don't really know a place in Dorset that does arch work though, so if anyone knows anywhere in or around Dorset let me know 

5 hours ago, KyleR said:

Run 245/35 fronts and 275/35 rears, should fit.

Wont that be quite a stretch on 11j?

I cant stand the look of stretched tyres.

2 minutes ago, StevoD said:

No mate 

 

that 10.5 in the rear only btw

With a 9.5 front I assume? with 255s?

3 minutes ago, StevoD said:

yes

this is my car in around 2012 

19x10.5 et 20 275/35/19

 

Couldn't fit your finger between inner lip and the tyre, if i ran a 295 on this it would have been in contact 

 

Did you have any arch work done? That fitment is perfect 

1 minute ago, StevoD said:

Rear tyres will rub 

Needs rolling and maybe flaring I take it? 

BTW That looks amazing.... What size are they?

I'm looking for some alloys for the zed. Currently running the standard rays with bc coilovers and a minimal drop. Arches are not currently rolled and i'm not adverse to having them rolled either.

I really have my eyes on the jr18's, if anyone has any pictures of their cars running these that would be great!

Question is will a 19x9.5 et22 (255/35/19) up front and a 19x11 et20 (295/35/19) at the rear, be suitable for my car?

My zed has brembos front and back, thanks for the help