pauljames90

Only item available now is the nissan badge

PM sent Lewis_UK

Stubby Ariel now sold

PM sent to both

Just sold my 350z GT4 so here's a collection of all the bits and pieces i've taken off for sale. All parts are available to post but collection is preferred due to cost these days! I'm located in Doncaster, South Yorkshire

Cosworth Panel Filter

Fits 03-06 DE engines, direct replacement for original panel filter. Hardly used and in very good condition!

£25 + (£5 postage) Provisionally Sold

Tomei Duracon Gear Knob

90mm tall, threaded inside so just unscrew the old on and screw this on. Very good condition and looks great in the z's cabin!

SOLD

Tarmac Sportz RDX 350Z Stubby Ariel

Nice replacement for the ugly original one. Like new and just screws on

SOLD

Tarmac Sportz Carbon Fibre Slam Panel

Genuine carbon fibre, fits 03-06, in good condition with 2 slight wear marks that can be seen on the picture.

SOLD

Original Nissan Front Badge

Good condition with usual wear and tear, was only takes off as a zed badge was fitted!

£5 + (£2 postage)

JWT Popcharger Intake with Heat Shield

Fits 03-06 DE engine z, both cone filter and heat shield are in good condition (slight mark hear ans there). Was cleaned using k&n cleaning kit approximately 3 months ago. Gives a great induction noise!

SOLD

Tarmac Sportz 20mm & 25mm Wheel Spacers

Full set of 2x 20mm front wheels spacers and 2x 25mm rear wheels spacers. The spacers are complete with lug nuts supplied by Tarmac Sports and are 5x114.3. Straight bold on design. All four are in great condition and give the car a much improved stance.

£120 + (£25 postage) Provisionally Sold

Any questions about any of the items for sale please don't hesitate to ask!

Thanks for the reply, and well my mates got an OBD reader so I'll get that connected up and see if it throws any faults up.

Over the last few weeks i've noticed my car feeling as though something wasn't quite right, not feeling as eager as it used too, the exhaust tone sounds flat (cobra back box and y-pipe), and excessive amounts of black soot on the tail pipe.

Strangely the car drives fine, no knocking or strange noises just seems flat and lacking in power somewhat.

I initially suspected it might be a dirty maf but cleaning this hasn't really improved anything so contemplated replacing it to see if it was faulty.

Any ideas of what could be causing these issues?

Did an ecu reset this morning and the eml sequence flashes 10 slow as it should then 10 fast, 10 fast and 10 fast again followed by the 10 slow to finish, any ideas how to match this to a code?

In a strange way the car drives absolutely fine and, at low revs there's a rasp that sounds like a leak in the system and when you turn the engine off there's a rattle that dies with the engine

Hi guys having a bit of a dilemma atm, basically I had my new cobra exhaust install last Monday and had 5 days of pure delight with the car running and sounding fantastic, then on the fifth night I came to drive home from work and I noticed straight away the car sounded different with no nice deep growl but just a weak sound similar to what the standard exhaust sounded like. It seems to be hesitant at rev'ing and I seem to be getting quite abit of mechanical noise at low revs.

Any ideas what could be the issue or any ways of finding out what it could be?

Loving the build mate, cars looking fantastic

 

Out of interest how you finding the scorpion exhaust? (Its on my list of things to buy)

 

Thanks mate

 

I was sceptical about the Scorpion as on Youtube vids etc it seemed raspy but went for it and am v happy with its sound. Adds a nice rumble on startup, 2-4kish makes a lovely sound then tbh the pop chargers noise takes over from there. Quiet on motorway, bit of noise when prodded.

No worries bud

Seems like just the sound i'm after then, thanks for that

Loving the build mate, cars looking fantastic

Out of interest how you finding the scorpion exhaust? (Its on my list of things to buy)

Here for sale are my ChargeSpeed Carbon Bumper Reflector Cowls.

These are extremely rare and fit pre-facelift 350z 03-05. They are peel back and stick on so dead easy to fit!

Never got round to fitting them and now no longer have use for them.

Looking for £120 inc. postage!

Nope wasn't me, although I do work at the airport though so i'm always around that way.

I like the sound of that... Quite like to listen to a few exhausts in person!

Yeah I'd be interested to know the differences too as I'm interested in ordering a scorpion system soon.

I see loads on bawtry road on my route too and from work.

Just spotted this and thought it looks interesting.

http://www.ebay.co.u...=item3cede3f9fb

Cant seem to find much info on it either.

Well that's great to hear, I just want something that can be usable everyday and on the motorway but still sounds nice, milltek sounds like the perfect choice

Looks spot on that mate How different would you say it is to the oem exhaust (tone, volume etc) I'm going through the same decision making as you with milltek or cobra!

Well good to see there's a few of us in the same area.

All fitted, great quality as expected and I'm surprised to say how much more planted the car now feels with them, not just to mention how awesome it now looks!

Impressed with the look of quality and feedback these have got, and it's my birthday next Wednesday so I might have to treat myself to one of these!

Just fitted popcharger this morning so going to see what difference it make in noise ðŸ‘

Spotted two on Bawtry road yesterday, first was a black 350z convertible just by Rossington junction, cheers for the wave

And second was a silver 350z just going by the racecourse.

Just wondered if you's are on here, I was in my kuro gt4!