Jump to content

Drivers door window 2004 350Z


N13GEY

Recommended Posts

I've a problem with the window, occasionally not operating when using the switch. It cant be the motor as the window usually goes up and down. I reckon its a loose connection or.....? Anyone had the same issue/know of a remedy? 

Link to comment
Share on other sites

  • 2 weeks later...

I’ve seen a couple of YouTube clips showing door window motors being changed. Not convinced the motors HAD to be changed. Gut feel is that it was something other than a motor issue. Anyone any ideas/ comments/ thoughts?

Link to comment
Share on other sites

34 minutes ago, N13GEY said:

I’ve seen a couple of YouTube clips showing door window motors being changed. Not convinced the motors HAD to be changed. Gut feel is that it was something other than a motor issue. Anyone any ideas/ comments/ thoughts?

See my post above: ^^^^^^^

Link to comment
Share on other sites

My money is on the motor. Had this issue for about 2-3years and finally got an eBay's special motor to replace. Mine was working fine all year and will stop working every now and then. I tried to fix them previously by cleaning the motor and last year the motor finally give up. Whilst i got the motor out for cleaning, i greased up all the mechanism thought it might be one of the cause but after few months the motor stopped working again. If you do get an eBay's special (£25-£30 each), remember to get one with a reset switch as some of them comes with none. Its a little black nipple on the round metal casing.


While you had the door card out to find route cause, might as well swap the motor since you already had them in bits. Mine's a 2004 zed as well and i should had just swapped the motor 1st time removing the door card to clean the motor.

Edited by veeg33
Link to comment
Share on other sites

I’ve seen a couple of YouTube clips showing door window motors being changed. Not convinced the motors HAD to be changed. Gut feel is that it was something other than a motor issue. Anyone any ideas/ comments/ thoughts?

 

 

 

Thanks, guys! I’m off to eBay for the bits. Success is around the corner!

Link to comment
Share on other sites

https://www.ebay.co.uk/itm/A-Premium-Front-Right-Window-Regulator-Motor-for-Nissan-350Z-Z33-Skyline-V35/163699495383?_trkparms=aid%3D555018%26algo%3DPL.SIM%26ao%3D1%26asc%3D58649%26meid%3Ddb3f6f5c47eb4572a01aa8c4bdb9a059%26pid%3D100005%26rk%3D2%26rkt%3D12%26sd%3D173702791417%26itm%3D163699495383&_trksid=p2047675.c100005.m1851

 

EBay's specials should work if not (link above, check when they arrive to ensure it has the reset button, as mentioned, black nipple on the round metal casing) or buy from Alex for 100% correct part.

 

If you are swapping it alone, i recommend duck tape to stop the window from dropping, use lots of them to stop it dropping whilst you are replacing the motor as you'll pretty much unbolt everything that's holding the window up. If it has moved or dropped, you'll need to reset it which can be a pain.

Link to comment
Share on other sites

1 hour ago, N13GEY said:

Always good, Paul to know this! Having been on EBay, not sure if you meant to buy from the US (high postage cost) or from a UK supplier. Any thoughts?

Hi mate I bought mine a few years ago from ebay UK, when I got the the motors they were already set in the up position so there was no need to do reset procedure, but get one with reset button just incase it's needed in the future, strongly recommend that you have a spare pair of hands to hold the glass up, I am really not mechanically minded but still managed to get this part fitted, just take your time with it

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...